5. With the insert material under the roller or bar, adjust the gap so there is very little (almost no) drag
on the insert. The goal is that the gap be tight enough for one piece to easily fit under, but not two
or more pieces.
l If there is no drag, turn the separator knob counterclockwise until you feel a slight drag
l If there is too much drag, turn the separator knob clockwise until you feel a slight drag.
6. When you have the correct amount of drag , remove the sample insert material.
7. Adjust the position of the pack control ramp. (Refer to the topic on Adjusting the Booklet Feeder
Pack Control Ramp for details.)
Operator Adjustments
Pitney Bowes Epic v3.1 (ZVE0) Operator Guide May, 2018 Page 147 of 328
To Next Page
Loading...