Setting Up the Vertical Stacker
The vertical stacker is primarily used to transport material. It can also be used as a diverter, depending on
the application.
This adjustment is only performed when stacker material is changed or possibly after a service call.
1. Use the operator setup tool to loosen the screw that holds the wheel to the bracket to adjust the
direction of travel of the envelope.
Vertical Stacker - Screws on Wheels
2. Angle the roller more to the right to direct the envelope toward the back wall of the vertical stacker.
(Sliding the roller to the left will steer the envelope away from the back wall.)
3. Tighten the rollers.
Note:
Rollers are used to correct small amounts of skew or misalignment only; adjustments should be slight.
Always check upstream of where the skew / misalignment occurred to see if another area is the issue.
Operator Adjustments
Pitney Bowes Epic v3.1 (ZVE0) Operator Guide May, 2018 Page 82 of 328
To Next Page
Loading...