Epic V-Bin (Y31E, Y31F, Y31G, Y31H )
The Y31 series V-Bin modules are optional output devices used on the Epic platform and on non-
turnover MSE/Rival systems. It diverts finished envelopes out of the mailstream prior to the On-Edge
Stacker.
When the divert gate is activated, the V-Bin diverts a single envelope from the mailstream. The diverted
envelopes are stacked in a tray located below the V-Bin transport. When the divert gate is not activated
the envelope is transported to the next downstream module. Setting up the V-Bin is part of the job setup
and is done through the Direct Connect operating system.
The V-Bins are available in both single and dual configurations and are factory configured for front
justified, face down (pre-Turnover) and rear justified, face up (post-Turnover) configurations.
Available Modules
Pre-Turnover
l Y31E (Single V-Bin, Front Justified)
l Y31F (Dual V-Bin, Front Justified)
Post-Turnover
l Y31G (Single V-Bin, Rear Justified)
l Y31H (Dual V-Bin, Rear Justified)
l Y31J (Single V-Bin/DM Infinity Meter Combo)
For the most cost-effective solution, dual V-Bin modules should be used wherever possible, unless an
odd number of V-Bins is required. In this case, a single module can be used at the end. For example, to
get three output V-Bins pre-Turnover we would use one Y31F followed by one Y31E. If we require four
V-Bins in a row, we would use two Y31F. Same rules apply for post-Turnover V-Bins.
The V-Bin modules provide the mounting base and electrical connections for top or bottom scanning or
the Shingle Conveyor. These options are mutually exclusive and therefore only one option per V-Bin is
permitted.
Specifications
Pitney Bowes Epic v3.1 (ZVE0) Operator Guide May, 2018 Page 314 of 328
To Next Page
Loading...