Job Changeover Guidelines
There may be areas of the system that you need to adjust when you are preparing to changeover to
another job with different material. Changeover adjustments may be required if the new job you are
about to run has material that is a different orientation (portrait or landscape), size or material thickness
than the previous job.
Use this table as a guideline to help identify what, if any, adjustments you need to make for a job
changeover. Some of these adjustments the system performs automatically, and some an operator
performs manually. Refer to the "Operator Adjustments" chapter in this guide for detailed procedures.
* - auto adjust
x = manual adjustment
Mailer Envelope -
changes size or style
Insert - changes size or
thickness
Control Document -
changes length, width,
thickness
Envelope Feeder
Separator Gap x
Fence Rollers x
Engine Setup GUI Screen x
Engine
Pocket Width *
Horn Position *
Horns Style / Thickness x x x
Suction Cup Location x
Tongue Position x
Tongue Height x x
Observation Guides
*
Backwall *
Job Changeover Guidelines
Pitney Bowes Epic v3.1 (ZVE0) Operator Guide May, 2018 Page 182 of 328
To Next Page
Loading...