Adjusting Amount of Sealer Fluid Applied
The sealer is where the envelope flap is moistened and the flap is closed. Operators can adjust the
amount of sealer fluid applied using DC. There are no mechanical adjustments available to operators on
the sealer.
Adjusting Amount of Sealer Fluid
The default amount of fluid applied to the envelope is determined by the envelope parameters entered in
the Engine Setup screen in DC. The amount of fluid used to seal the envelopes may need to be adjusted
during mail processing based on the type of envelope material.
1. Click the Sealer object on the main DC screen and select Sealer Control from the drop-down.
Sealer Object
Operator Adjustments
Pitney Bowes Epic v3.1 (ZVE0) Operator Guide May, 2018 Page 80 of 328
To Next Page
Loading...