Operator Adjustments
There are several adjustments (both mechanical and through the software GUI) operators can make
during job setup, running a job and troubleshooting activities. These adjustments are grouped by areas of
the system to make it easier to find the procedures.
l Envelope Feeder
l Engine
l Sealer
l Vertical Stacker
l On Edge Stacker (OES)
l Chassis
l Friction Feeders (insert feeder)
l Rotary Feeders (insert feeder)
l Booklet Feeder
l Buffer
Note:
After loading a mode, home the chassis by pressing the Start button once.
Job Changeovers
Changeover adjustments may be required if the new job you are about to run has material that is a
different orientation (portrait or landscape), size or material thickness than the previous job.
Some of the adjustments for a job changeover the system makes automatically, and some you need to
make manually. Refer to the "Job Changeover Guidelines" topic for detailed information.
Operator Adjustments
Pitney Bowes Epic v3.1 (ZVE0) Operator Guide May, 2018 Page 51 of 328
To Next Page
Loading...