5 - Operator
Adjustments
In this section
Operator Adjustments 51
Adjusting the Envelope Feeder Separator Gap 52
Adjusting the Envelope Fence 55
Adjusting the Suction Cups in the Engine 56
Adjusting the Engine Tongue Position 60
Adjusting the Engine Tongue Height 63
About Engine Horns 65
Changing Engine Horns 66
Envelope Settings 71
Setting Up the RAT (Right Angle Transfer) 78
Adjusting Amount of Sealer Fluid Applied 80
Setting Up the Vertical Stacker 82
Moving the Flat Stacker 84
About the On Edge Stacker (OES) 88
Setting Up the Entrance to the On Edge Stacker 90
Centering Mail on the On Edge Stacker Conveyor Belt 94
Adjusting the Belt Speed and Stack Pressure on the On
Edge Stacker 96
Adjusting On Edge Stacker Fingers 100
Adjusting Chassis Material Center Deck Control Strap 102
Adjusting Chassis Side Guide Control Straps 104
Setting the Chassis Collation Length 105
Setting the Chassis Speed 107
Friction Feeder Mechanical Adjustments 109
Adjusting the Friction Feeder Separator 110
Adjusting the Friction Feeder Side Guides 113
Adjusting the Feeder Pack Control Ramp 116
Rotary Feeder Mechanical Adjustments 118
To Next Page
Loading...