Setting Up the Entrance to the On Edge Stacker
To help make sure the On Edge Stacker (OES) stacks mail properly, use these setup guidelines.
1. For proper stacking height the envelope must be set to 1/2-inch (12.7 mm) off the deck.
Item Description
1 1/2-inch (12.7 mm) Offset from Deck
2 Paper Flow and Stacker Exit
Envelopes Set to 1/2-inch (12.7 mm) Off the Deck (shown here in closeup)
2. To adjust the height, move the actuator switch up or down.
3. After setting the proper height, adjust the entrance guides to keep the same height consistent.
Operator Adjustments
Pitney Bowes Epic v3.1 (ZVE0) Operator Guide May, 2018 Page 90 of 328
To Next Page
Loading...