Clear Deck Function
The Clear Deck function starts an operating sequence that clears all the mailpieces from the paper path.
Typically you use this option at the end of a job or before you start a new job, if the paper path is not clear.
How to Initiate Clear Deck
When you are logged in as an Operator, you can initiate clear deck. There are three ways to do this:
l Click the Menu button on the bottom of the main DC screen and select Clear Deck from the
menu.
l Press and hold the Cycle button on the remote control (wait for about 1 second), and then press
the Stop button while still holding down the Cycle button.
l Click the Chassis object on the main DC screen and select Clear Deck from the menu.
What Happens When Clear Deck is Initiated
l If the machine is running when Clear Deck is initiated, all the material in the paper path will be
processed and cleared from the machine.
l If the machine is not running when Clear Deck is initiated, the next time the machine is started, all
mail that was being processed is completed and then the system will stop.
Once initiated, the Clear Deck message flashes at the bottom of the screen.
Using Direct Connect
Pitney Bowes Epic v3.1 (ZVE0) Operator Guide May, 2018 Page 43 of 328
To Next Page
Loading...