Adjusting the Envelope Feeder Separator Gap
The envelope feeder separator sets the gap, so only one envelope feeds at a time. The size of the gap is
set based on envelope thickness. If the gap is too tight, envelopes will not feed. If the gap is open too
wide, multiple envelopes will feed.
1. Pull the separator access lever towards you until it stops and hold it in place.
Pull Back Separator Access Lever
Operator Adjustments
Pitney Bowes Epic v3.1 (ZVE0) Operator Guide May, 2018 Page 52 of 328
To Next Page
Loading...