Insert Feeder Software Adjustments
There are several software adjustments operators will need to perform on the friction feeders to be
prepared for successful job runs. Some of these activities are available to operators and some activities
are for key operator levels and higher.
The activities for each access level are grouped here. Be sure you are logged into DC at the correct level
to access these features.
Adjustment Friction Feeder Rotary Feeder Access Level
Enable and Disable Feeders • • Operator
Document Information • • Key Operator
Feed Modes • • Key Operator
Backup Feed Mode • • Key Operator
Xport Setup • • Key Operator
Separator Control • Operator
Recalibrate Double Detect • • Operator
Operator Adjustments
Pitney Bowes Epic v3.1 (ZVE0) Operator Guide May, 2018 Page 163 of 328
To Next Page
Loading...