3. Withdraw the envelope from the WP and insert it into the mail path against the
rear-guide wall, side to be printed facing upwards.
If mail piece is bigger than mail path maximum thickness (see Mail
Specifications on page 207), you may use a label tape.
4. The Mailing System applies the impression and the mail piece (or label) is sent to the
catch tray.
In other modes (Manual weight entry, No weight source).
From the [Permit] home screen, to print on mail pieces:
1.
Press . System motors start running.
2. Insert the envelope (or a label) into the mail path against the rear-guide wall, side to
be printed facing upwards.
If mail piece is bigger than mail path maximum thickness (see Mail
Specifications on page 207), you may use a label tape.
The Mailing System applies the impression and the mail piece (or label) is sent to the
catch tray.
3
Processing Mail
43
| Page 43 | Jan-13-2017 10:32 |
To Next Page
Loading...
