Processing Mail in [Date Correction] Mode
To run mail, follow the procedure below after you have completed the steps in Setting [Date
Correction] Mode on page 44.
Before printing, turn the envelope to print on a free area.
How to Process Mail in [Date Correction] Mode
To print the new date impression:
1.
Press .The system motors start running.
2. Insert the envelope (or a label) into the mail path against the rear-guide wall, side to
be printed facing upwards.
The Mailing System applies the impression and the mail piece (or label) is sent to the
catch tray.
If mail piece is bigger than mail path maximum thickness (see Mail
Specifications on page 207), you may use a label tape.
46
| Page 46 | Jan-13-2017 10:32 |
3
Processing Mail
To Next Page
Loading...
Need help?
General
