Processing Mail in [Postage Value Correction] Mode
To run mail, follow the procedure below after you have completed the steps in Setting
Postage [Value Correction] Mode on page 47.
How to Process Mail in [Postage Value Correction] Mode
To print a Postage Value Correction Impression:
1.
Press .The system motors start running.
2. Insert the envelope into the mail path against the rear-guide wall, with the side to be
printed facing upwards.
The Mailing System applies postage and the envelope (or the label) is sent to the
catch tray.
If a mail piece is bigger than mail path maximum thickness (see
Mail Specifications on page 207), you may print on a label instead.
3
Processing Mail
49
| Page 49 | Jan-13-2017 10:32 |
To Next Page
Loading...
