2. Check or change the type of impression, if you are not in [Seal Only] mode.
Press to access the Build Impression screen:
To change the type of impression, select the Type line, press [OK] and then select
[No printing] in the Type of impression screen and press [OK].
To select an option in the screen:
- Highlight the option using the arrow keys and
- Then press to validate your selection.
3.
Press or to return to the home screen.
You are now ready to process mail.
Processing [Seal Only] Mail
To run mail, follow the procedure below after you have completed the steps in How to Set
[Seal Only] Mail on page 57.
How to Process [Seal Only] Mail
1.
Press . System motors start running.
58
| Page 58 | Jan-13-2017 10:32 |
3
Processing Mail
To Next Page
Loading...
