Default Sealing Mode10.9
As supervisor, you can set the default sealing Mode (ON or OFF).
This setting is used only if the Mixed-Size Feeder is connected.
How to Set the Default Sealing Mode
To modify the Default Sealing Mode:
1. As supervisor (see How to Log in as Supervisor on page 241):
From the main menu, select the path: Default user settings Base settings
Default sealing state
2. Change the default sealing state as required.
3. Press [OK] to validate.
282
| Page 282 | Jun-22-2021 11:01 |
10
Configuring your Mailing System
To Next Page
Loading...
