4. Lift the metal retainer to remove the sponge.
Remember its direction.
5. Clean the sponge and the brush.
6. Re-install the sponge and retainer.
7. Put the brush back and push the release lever back down until it snaps into place.
8. Push down on the upper drive assembly until it locks back into position.
How to Adjust the Sealing Water Flow
Before you adjust the sealing water flow, make sure that the brushes and sponge are
clean.
To adjust the sealing water flow:
338
| Page 338 | Jun-22-2021 11:01 |
12
Maintaining
To Next Page
Loading...
