1.
Press . System motors start running.
2. Insert the mail piece into the mail path against the rear-guide wall, side to be
printed facing upwards.
The Mailing System applies the imprint and the mail piece is sent to the catch tray.
How to Set [Pass Through] Mail processing
This section describes how to use the [Pass Through] type of imprint, for:
• Sealing envelopes using the auto-feeder sealer (if installed).
• Only conveying mail, for counting or testing purposes.
Main setting:
56
| Page 56 | Jun-22-2021 11:01 |
3
Processing Mail
To Next Page
Loading...
