Using the Feeder
The procedure below describes how to place a stack of mail pieces in the Hopper.
Depending on the weighing method you choose to run mail, you may have to insert
the envelopes one by one or place a stack of envelopes in the hopper.
Each stack may mix envelopes of different thickness and size.
How to Use the Feeder
Feeding a stack of mail pieces:
1. Arrange the mail pieces according to their size (the largest/heaviest letters
beneath).
2. Fan the envelopes to separate them.
3. Bevel the edge of the stack.
4. Place the envelopes in the hopper, their upper edge resting against the rear guide.
Ensure that all the envelopes are stacked along the rear guide, from largest to
smallest.
40
| Page 40 | Jun-22-2021 11:01 |
3
Processing Mail
To Next Page
Loading...
Need help?
General
