1.
Press and enter the number of labels.
Make sure there is enough labels are available in the label dispenser (see Filling
the Label Dispenser on page 101).
2.
Press to print the labels.
In optional mode Differential Weighing ( ):
From the [Normal] home screen:
1. Place the stack of mail to process on the Weighing Platform, then follow the
instructions on the screen or the steps below.
2. Remove the first mail piece from the top of the stack. The Mailing System displays
weight and postage on the home screen and starts motors automatically.
3. To print the imprint, insert the mail piece into the base against the rear-guide wall,
with the side to be printed facing upwards.
If a mail piece is bigger than mail path maximum thickness, press to print a
label. The label is printed. To know the maximum thickness, see Mail Specifications
on page 367.
4. The Mailing System applies postage and the mail piece (or label) is sent to the
catch tray.
When sealer is activated, collect the mail piece stack in the catch
tray and put stack aside to let envelopes dry.
3
Processing Mail
47
| Page 47 | Jun-22-2021 11:01 |
To Next Page
Loading...
Need help?
General
