42
ESP-LXIVM Series Controllers
Set Watering Start Times
Start times are the time(s) of day that the program begins.
You can assign up to 8 Start Times to a single program. Multiple Start
Times allow you to run a program more than once on each day. For
example, if you’re growing new lawn seed, you may want to water
several times a day to keep the seedbed or top dressing damp.
NOTE: Start times apply to the entire program and not just to an
individual station.
Turn the controller dial to Start Times
At the Set Start Times screen, press the + or – key to activate the
1st Start Time.
Press the + and – keys to set the hour, then press the Right Arrow
key. Press the + and – keys to set the minutes.
SET START TIMES
PGM1
OFF
1st
SET START TIMES
PGM1
00:00 PM10
1st
NOTE: If the desired program is not selected, press the Program
Select switch to change it. See "Program Select Button" on page
41 for more details.
Press the Arrow keys to navigate between the number setting
fields. Press the + and – keys to set additional Start Times (1
through 8).
SET START TIMES
PGM1
10:20 PM
2nd
Change the Program Select switch and repeat this process to
set up additional Watering Start Times for other programs as
desired.
NOTE: Cycle+Soak™ is an alternative method of dividing the
total Station Run Time into smaller cycle times. If you plan to use
Cycle+Soak, only a single Watering Start Time is required for each
program. See "Cycle+Soak™" on page 33 for more details.
To Next Page
Loading...
Need help?
General
