93
ESP-LXIVM Series Controllers
Clear Program Information
The ESP-LXIVM controller allows you to clear an individual Program,
all of your Programs or Restore the controller to it’s factory default
condition.
NOTICE
It’s recommended to back up your Programs before clearing
them. The LX-IVM controller’s built in Store Programs feature
can backup one set of programs. See "Store/Recall Programs"
on page 90 for more details.
NOTE: Irrigation start days, Start Times and station Run Times
will no longer be present for the cleared Programs. If no Pro-
gramming exists then an Alarm will be shown. See "Alarms" on
page 21 for more details.
Clear Individual Program
Turn the controller dial to Advanced Settings
At the IQ / ADVANCED screen, with Store/Recall Programs
selected, press Next.
At the Program Options screen, press the Down Arrow key to
select Clear Programs, then press Next.
NOTE: If the desired program is not selected, press the Program
Select button to choose the desired program. See "Program
Select Button" on page 41 for more details.
IQ / ADVANCED
About this LX-IVM
Configure Cartridge
Factory Defaults
Store/Recall Programs
Program Options
Clear Programs
Delayed Recall
Recall Programs
Store Programs
At the Clear Programs screen with Individual Programs selected;
press Next.
At the confirmation screen, press and HOLD the Yes key for 4 sec-
onds to Clear Programs. If you’re not sure, press No.
Clear Programs
All Programs
Individual Programs
Clear PGM 01
Are you sure? Press and hold
Yes to proceed.
A confirmation screen shows the process is complete.
Clearing Done
Change the Program Select switch and repeat this process to
clear other Programs.
To Next Page
Loading...
Need help?
General
