R&S ZNA67 - Page 1240

Command reference
R&S
®
ZNA
1240User Manual 1178.6462.02 ─ 20
[SENSe:]CONVerter<Port>:RFPort?
Returns the VNA source port that drives converter <Port>.
Always returns <Port>.
Suffix:
<Port>
.
Converter number
Usage: Query only
Options: R&S ZNA-K8
Manual operation: See "Source" on page 829
[SENSe:]CONVerter<Port>:RFSLope
<Slope>
Suffix:
<Port>
.
Parameters:
<Slope> Default unit: DB/GHZ
Manual operation: See "Slope" on page 620
[SENSe:]CONVerter<Port>:STATe <Boolean>
Activates or deactivates converter <Port>.
Suffix:
<Port>
.
Converter number = VNA port number
Parameters:
<Boolean>
Options: R&S ZNA-K8
Manual operation: See "Active" on page 829
7.3.14.5 SENSe<Ch>:CORRection:ADVanced
Remote control commands for advanced calibration features.
[SENSe<Ch>:]CORRection:ADVanced:HARMonic:ORDer?
Returns the list of harmonic orders at which the source and receiver power calibration
shall be performed for harmonics measurements in channel <Ch>.
Use [SENSe<Ch>:]CORRection:ADVanced:HARMonic:ORDer:ADD/
[SENSe<Ch>:]CORRection:ADVanced:HARMonic:ORDer:REMove to add/remove
harmonic orders to/from this list.
Use SOURce<Ch>:POWer<PhyPt>:CORRection:HARMonic[:ACQuire] and
[SENSe<Ch>:]CORRection:POWer<PhyPt>:HARMonic:ACQuire) to calibrate.
SCPI command reference