R&S ZNA67 - Page 1374

Command reference
R&S
®
ZNA
1374User Manual 1178.6462.02 ─ 20
Manual operation: See "Port" on page 643
[SENSe<Ch>:]PULSe:SYNCron[:STATe] <Sync measurement to pulses>
Suffix:
<Ch>
.
Parameters:
<Sync measurement
to pulses>
Manual operation: See "Sync Meas to Pulse Gen." on page 645
[SENSe<Ch>:]PULSe[:STATe] <On/Off for muple modulation>
Suffix:
<Ch>
.
Parameters:
<On/Off for muple
modulation>
7.3.14.24 [SENSe:]ROSCillator...
The [SENSe:]ROSCillator... commands control the frequency reference signal.
[SENSe<Ch>:]ROSCillator[:SOURce] <Source>
Selects the source of the reference oscillator signal.
Parameters:
<Source> INTernal | EXTernal | ESMA
INTernal – internal 10 MHz reference oscillator
EXTernal – external reference clock via BNC connector
ESMA – external reference clock via SMA connector
The frequency of the external reference clock can be defined
using [SENSe:]ROSCillator:EXTernal:FREQuency
*RST: INTernal
Example: See [SENSe:]ROSCillator:EXTernal:FREQuency
on page 1374.
Manual operation: See "Reference Source" on page 812
[SENSe:]ROSCillator:EXTernal:FREQuency <ExtClockFreq>
Specifies or queries the frequency of the external reference oscillator.
SCPI command reference