R&S ZNA67 - Page 1468

Command reference
R&S
®
ZNA
1468User Manual 1178.6462.02 ─ 20
Manual operation: See "Cal Power Offset" on page 538
SOURce<Ch>:POWer<Pt>:EATTenuation <Manual ElSourceAtt>
Defines the electronic source attenuation at port <Pt> in channel <Ch>. This setting will
only take effect if SOURce<Ch>:POWer<Pt>:EATTenuation:MODE is set to MANual.
Suffix:
<Ch>
.
Channel number
<Pt> Port number
Parameters:
<Manual
ElSourceAtt>
Supported attenuation values are 0 dB, 20 dB, and 40 dB.
Default unit: dB
Manual operation: See "El. Source Att." on page 620
SOURce<Ch>:POWer<Pt>:EATTenuation:MODE <ElSourceAttMode>
Defines how the electronic source attenuation of port <Pt> is selected in channel
<Ch>.
Suffix:
<Ch>
.
Channel number
<Pt> Port number
Parameters:
<ElSourceAttMode> AUTO | MANual
AUTO
The firmware selects the suitable electronic attenuation value.
MANual
You can select the electronic attenuation value using
SOURce<Ch>:POWer<Pt>:EATTenuation.
Manual operation: See "El. Source Att." on page 620
SOURce<Ch>:POWer<PhyPt>:GENerator<Gen>:OFFSet <Offset>, <Mode>
Defines the power of an external generator or its power offset relative to the channel
power (SOURce<Ch>:POWer<PhyPt>[:LEVel][:IMMediate][:AMPLitude]).
Suffix:
<Ch>
.
Channel number
<PhyPt> Test port number of the analyzer. This suffix is ignored; the gen-
erator is selected via <Gen>.
<Gen> Generator number
SCPI command reference