R&S ZNA67 - Page 387

GUI reference
R&S
®
ZNA
387User Manual 1178.6462.02 ─ 20
Related information
Refer to the following sections:
●
Chapter 4.1.3, "Traces, channels and diagrams", on page 85
●
Chapter 3.3.5, "Handling diagrams, traces, and markers", on page 62
In remote control, each channel can contain an active trace. The active remote traces
and the active manual trace are independent of each other; see Chapter 6.3.2, "Active
traces in remote control", on page 859.
5.5.1.1 Controls on the Traces tab
The "Trace Manager..." button opens the Trace Manager dialog.
Active Trace
Selects an arbitrary trace of the active recall set as the active trace in its channel and
diagram. At the same time, it sets the trace's diagram and channel as the active Dia-
gram / Channel.
Tip: You can also select an item in a trace list or a trace line in a diagram to make the
related trace the active one.
This function is disabled if only one trace is defined.
Add Trace
Creates a trace in the active Diagram / Channel and makes it the Active Trace.
Traces softtool