GUI reference
R&S
®
ZNA
555User Manual 1178.6462.02 ─ 20
Data of completed calibrations are saved, data of incomplete calibrations are discar-
ded.
5.11.1.8 Channel Selection for Calibration dialog
If you initiate a guided calibration and there is more than one channel in the current
recall set, you are prompted to select the channels to be calibrated:
Use
●
"Active Channel" if you only want to calibrate the active channel
●
"All Channels" if you want to calibrate all channels in the current recall set
●
"Selected Channels" if you want to calibrate only certain channels
5.11.1.9 Cal Validation dock widget
The controls on the "Cal Validation" dock widget allow you to set up and run a Calibra-
tion validation in basic or advanced mode.
Cal softtool
To Next Page
Loading...
