R&S ZNA67 - Page 840

GUI reference
R&S
®
ZNA
840User Manual 1178.6462.02 ─ 20
Physical
interface
(connector)
Interface
(protocol)
Address Remarks
USB USB-VISA
<ManID>::<ProdID>::<SerialNo>
e.g. 0x0AAD::0x0047::100098
2733 (0x0AAD) is the manufacturer ID of
Rohde & Schwarz.
The serial number is device-specific.
LAN or USB Other Interface-specific, e.g. for SOCKET:
TCPIP0::<IpAddress>::<PortNo>::SOCKET
For USB-VISA:
USB0::<ManID>::<ProdID>::<SerialNo>::INSTR
Use complete VISA resource string.
Remote command:
SYSTem:COMMunicate:RDEVice:GDEVice<Gdev>:DEFine
5.19.8.2 External Generic Device Config dialog
The "External Generic Device Config" is a Multi-channel setup dialog. It allows you to
select channel-specific commands (or rather command sequences) to be sent to the
configured generic devices during channel initialization.
Access: System – [Setup] > "Generic Device" > "Generic Device Config..."
●
If the previously measured channel uses the same command to control a generic
device, the command is not sent again.
●
After sending the command to the device, the analyzer waits for the "Settling Time"
requested in the loaded command file.
●
The execution order among the configured devices is undefined.
Background information
Refer to Chapter 4.7.40, "Generic devices", on page 292.
The "Device Name", "Interface", "Address", "Model", "Serial" and "State" columns allow
you to identify the connected device and to determine its operational state.
Config. File/Command
To configure a device for the channel selected in the title bar of the dialog, first pick a
configuration file for this device (column "Config. File") and then select one of the com-
mands defined in this configuration file (column "Command").
Note:
Setup softtool