R&S ZNA67 - Page 839

GUI reference
R&S
®
ZNA
839User Manual 1178.6462.02 ─ 20
The connection is defined with the following settings:
●
"Interface" selects an interface/protocol type for the connection. In addition to the
VXI-11, SOCKET, and GPIB interfaces, the analyzer supports any "Other" interface
supported by the installed VISA library.
USB-VISA devices are auto-detected and hence this interface type does not show
up here.
●
"Address" contains the address for the current interface type. GPIB addresses
must be unique for all devices connected to the GPIB bus (range: 0 to 30), GPIB
and IP addresses must agree with the entries in the VISA library. The remaining
interface types require composite address formats; see Table 5-11.
●
"Identify" sends an identification query ("IDN?") to the specified device address to
identify the model and serial number of the connected device.
Table 5-11: Interface types for external device and address formats
Physical
interface
(connector)
Interface
(protocol)
Address Remarks
LAN VXI-11
<IpAddress>
e.g. 127.0.0.0
Full VISA resource string:
TCPIP[board]::<Address>[::INSTR]
SOCKET
<IpAddress>::<PortNo>
e.g. 127.0.0.0::50000
LAN connection with pure TCP/IP protocol;
refer to your VISA user documentation.
GPIB GPIB0 ...
GPIB9
<Address>
e.g. 20
Full VISA resource string:
GPIB[board]::<Address>[::INSTR]
Setup softtool