Chapter 5: Standard Chart Operations 5-35
Transferring
Waypoints and
Routes
➤ To savewaypoints to, or load waypoints from a user cartridge:
CAUTION:
Loading waypoints froma user cartridgeoverwritesany existing
waypointand routelists.
1. Inserta C-MAP User Card into the lower of the two cartridgeslots.
1. Press MARK S followed by the LOAD/SAVE USER CARD soft key.
2. The User Card Menu and associatedsoft keys are displayed.
3. Press the SAVE WPT/RTE DATA TO CARD or LOAD WPT/RTE DATA FROM
CARD softkey;anappropriatewarningandYes/Nosoftkeysare displayed.
4. Press Yes to continueor No to abandonthe operation and returnto the pre-
vious screen.
5. If the operation is successful,confirmation of the number of Routes and
Waypoints saved/loaded is displayed.
If the operation fails, theSave Failed message is displayed.
MARKS
D5594-1
USER CARD PRESENT
WARNING
SAVING DATA TO THE USER
CARD WILL ERASE ALL EXISTING
WAYPOINT AND ROUTE DATA
ON THE CARD.
USER CARD MENU
ARE YOU SURE ?
YES NO
D5595-1
USER CARD PRESENT
SAVE COMPLETE
SAVED 2 ROUTE(S) AND
7 WAYPOINT(S)
USER CARD MENU
LOAD WPT/
RTE DATA
FROM CARD
SAVE WPT/
RTE DATA
TO CARD
CHECK
CARD IN
USER SLOT
81186_3.book Page 35 Thursday, August 22, 2002 8:23 AM
To Next Page
Loading...
