Chapter 5: Standard Chart Operations 5-37
Transferring
Waypoints and
Routes
➤ Toreceivethewaypointandroutelistsviahsb
2
,youmustset-upthetransferon
bothdisplay units - one unit will send waypoints, the other will receivethem.
CAUTION:
Receivingwaypointsfrom another
hsb
2
instrumentoverwrites any
existingwaypointand route lists.
1. Display the waypointlist as previouslydescribed,thenpress the WAY-
POINT TRANSFER soft key.
2. Pressthe softkey SEND WPT LIST ON HSB orRECIEIVE WPTS FROM HSB.You
areprompted to confirm:
PressNO to cancel the operation,then ENTER ifyouwishtoclosetheway-
point list.
Press YES to continue. The waypoint list is transmitted to/from the chart-
plotterfrom/to another instrument on
hsb
2
.Whilethedataisbeingtrans-
ferredthe soft key changes to STOP SENDING WAYPOINTS; when the
transfer is complete the soft key is re-displayed.
WAYPOINT
TRANSFER
81186_3.book Page 37 Thursday, August 22, 2002 8:23 AM
To Next Page
Loading...
