Raymarine St290 - Page 161

Chapter 2: Installation Procedures 6-2-21
ST290 Instrument System Owner’s Handbook
Figure 2-19: Flush mounting, step 1
Figure 2-20: Flush mounting, step 2
1 Remove appropriate template
from handbook, apply to
required location and mark
cutting centers for corners.
D5710-1
REM
OVE SHADED
A
REA ON
LY
Drill 1 inch (25 mm)
diameter
Drill 1 inch (25 mm)
diameter
Drill 1 inch (25 mm)
diameter
Drill 1 inch (25 mm)
diameter
D5361-1
ST290 Digital Instrument
Template
FLUSH MOUNT
TOP
Instrument edge
Instrument edge
4.37 in (111 mm )
5.3 in (160 mm)
2 Cut four holes for corners.
D5711-1
81183_2 S6.book Page 21 Wednesday, May 7, 2003 11:27 AM