6-2-22 Section 6: Installation
ST290 Instrument System Owner’s Handbook
Figure 2-21: Flush mounting, step 3
Figure 2-22: Flush mounting, step 4
D5712-1
3 Cut hole for instrument
or keypad rear section.
4 Feed cables through bracket, mounting
surface and seal, then connect to
instrument or keypad. Use studs and
thumb nuts to secure instrument or
keypad to mounting surface.
D5713-1
81183_2 S6.book Page 22 Wednesday, May 7, 2003 11:27 AM
To Next Page
Loading...
