Chapter 4: Commissioning the Autopilot 8-4-15
ST290 Instrument System Owner’s Handbook
To carry out AutoLearn, enter Seatrial Calibration, then:
1. Use the button to scroll to the PILOT AUTOLEARN screen in Seatrial
Calibration (Figure 4-9 ).
2. Use the or buttons to select ON.
Figure 4-9: Using AutoLearn
3. Steer straight ahead, with the rudder centered and prepare to start the
AutoLearn process:
• Power boats: set the boat’s speed between 8 and 15 knots. Plan-
ing boats should be OFF the plane.
• Sail boats: with sails down, motor the boat at typical cruising
speed.
• If conditions are not calm, head into the wind and waves.
4. When you are ready to start the AutoLearn, press the button.
D6008-1
The step number
increments to show
progress
AutoLearn complete
OR
To Pilot Calibration Swing Compass page
81183_2 S8.book Page 15 Tuesday, May 6, 2003 9:08 AM
To Next Page
Loading...
