Model 8210/8250 Maintenance Manual Section 3. Systems Overview
Operator Display and Programming
Publication:1146945/001, Revised: 25 Sep 2018 3-9
long. Release the thumb control when the
desired value is reached.
7. Press the horn button again to confirm the
new PIN-key code value. The parameter
indicator on the display stops flashing.
8. To enable additional operators; rotate the
thumb control in the fork direction to roll
over to the second operator, and stop at
parameter 10. The default value of “0” is
displayed. Follow the previous steps for
the desired number of different PIN-key
codes you want to set up. There are a total
of ten operators.
N
OTE: Disabling all operators (all PIN-key code
values = 0) prohibits truck operation
without the service key.
N
OTE: Use unique PIN-key codes to avoid
confusion. If two operators have the
same PIN-key code, the higher number
operator’s parameters are used. For
example if both the first and second
operator PIN-key code is 1111, and the
first operator’s max speed is 80% and
the second operator’s max speed is 90%,
when someone logs in with 1111 the
max speed used is 90%.
Property of American Airlines
To Next Page
Loading...