1,000-SHEET FINISHER INSTALLATION
SM 3-37 A265/A267
Installation
10. Secure the finisher (1 screw).
11. Adjust the securing knobs [A] under the front and rear stand until the finisher is
perpendicular to the floor.
12. Install the shift tray [B] (1 snap ring).
NOTE:
Make sure that the three pegs [C] fit into the slots [D] properly.
13. Connect the finisher cable [E] to the optional bridge unit.
14. Attach the staple position decal [F] to the ARDF as shown.
15. Turn on the main power switch and check the finisher operation.
A681I103.WMF
A681I501.WMF
[A]
[B]
[C]
[D]
[E]
[F]
To Next Page
Loading...
