Ricoh Aficio 270 - Page 195

SERVICE PROGRAM MODE
SM 4-9 A265/A267
Service
Tables
Mode No.
Class
1 and 2
Class
3
Function Settings
Adjusts the upper paper lift motor forward
rotation time for paper sizes larger than the
small size threshold set with SP1-908-8, up
to and including the middle size threshold
set with SP1-908-9.
The motor rotates forward when the amount
of remaining paper is lower than the value of
SP1-908-7.
If a middle size threshold is not stored with
SP1-908-9, this SP is not used.
5
1st Bottom Plate
Pressure
Re-adjustment
(Middle Size)
Use this SP when a paper feed problem
occurs when paper in the 1st paper tray is
running low.
See “Paper Lift Mechanism” for details on
SP1-908, Section 2.8.4.
0 ~ 2000
1 ms/step
300 ms
Selects the remaining paper amount limit for
use with SP1-908-4.
6
1st Paper Amount
(Small Size)
Set this SP to 2 or 3 when a paper feed
problem occurs before near-end.
See “Paper Lift Mechanism” for details on
SP1-908, Section 2.8.4.
0: None
(Empty)
1: Near End
2: 25%
3: 75%
Selects the remaining paper amount limit for
use with SP1-908-5.
7
1st Paper Amount
(Middle Size)
Set this SP to 2 or 3 when a paper feed
problem occurs before near-end.
See “Paper Lift Mechanism” for details on
SP1-908, Section 2.8.4.
0: None
(Empty)
1: Near End
2: 25%
3: 75%
Selects the small size threshold for the 1st
paper tray.
“0” means that this setting is not used.
8
1st Small Paper Size
Setting
The size used by SP1-908 is determined by
paper width. See “Paper Lift Mechanism” for
details on SP1-908, Section 2.8.4.
NOTE:
The “T” after A4 and LT refer to
lengthwise feeding direction.
0: None
(Not used)
1: HLT/A5
2: A4T
3: LG, LTT
4: DLT, LT
5: A3, A4
Selects the middle size threshold for the
upper tray.
“0” means that this setting is not used.
1-908*
9
1st Middle Paper
Size Setting
The value must be larger than the small size
threshold (SP1-908-8). The size used by
SP1-908 is determined by paper width. See
“Paper Lift Mechanism” for details on SP1-
908, Section 2.8.4.
NOTE:
The “T” after A4 and LT refer to
lengthwise feeding direction.
0: None
(Not used)
1: HLT/A5
2: A4T
3: LG,LTT
4: DLT,LT
5: A3,A4
⇒
Rev. 03/2000