Ricoh Aficio 270 - Page 238

SERVICE PROGRAM MODE
A265/A267 4-52 SM
Mode No.
Class
1 and 2
Class
3
Function Settings
Selects the range for which binding holes in
originals are ignored.
If set at “0”, this function is disabled.
6-911*
Binding Hole Range
An original jam may occur when an original
with binding holes is fed, because these
holes are detected by the sensors. Use this
SP to avoid this problem. For example,
when this value is set to “12 mm”, this
machine ignores binding holes within 12 mm
of the trailing edge of the original.
0 ~ 20
1 mm/step
12 mm
7-001*
Total Operation
Time
Displays the total operation time (total drum
rotation time).
1
Total Original
Counter (All Modes)
Displays the total number of scanned
originals (all modes).
2
Total Original
Counter (Copier)
Displays the total number of scanned
originals (copy mode only).
7-002*
3
Total Original
Counter (Fax)
Displays the total number of scanned
originals (fax mode only).
1
Total Print Counter
(All Modes)
Displays the total number of prints (all
modes).
2
Total Print Counter
(Copier)
Displays the total number of prints (copier
mode).
3
Total Print Counter
(Fax)
Displays the total number of prints (fax
mode).
7-003*
4
Total Print Counter
(Printer)
Displays the total number of prints (printer
mode).
7-004*
CE Counter Setting
This SP mode is effective only when the
CSS board is installed.
Do not change the value.
1
Copy Counter -
Paper Size (A3)
2
Copy Counter -
Paper Size (B4)
3
Copy Counter -
Paper Size (A4)
4
Copy Counter -
Paper Size (B5)
5
Copy Counter -
Paper Size (DLT)
6
Copy Counter -
Paper Size (LG)
7
Copy Counter -
Paper Size (LT)
8
Copy Counter -
Paper Size (HLT)
7-101*
9
Copy Counter -
Paper Size (Others)
Displays the total number of copies by paper
size.
7-201*
Total Scan Counter Displays the total number of scanned
originals.
7-204* 1
Copy Counter -
Paper Tray (1st)
Displays the total number of copies fed from
each paper feed station.