Ricoh Aficio 270 - Page 237

SERVICE PROGRAM MODE
SM 4-51 A265/A267
Service
Tables
Mode No.
Class
1 and 2
Class
3
Function Settings
Adjusts the trailing edge erase margin in the
ADF mode.
3
ADF Registration
(Trailing Edge
Erase)
Use the
!
key to toggle between + and -
before entering the value. See
“Replacement and Adjustment - Copy
Adjustment” section 6.8 for details.
–3.0 ~ +3.0
0.1 mm/step
-1.0 mm
Adjusts the side-to-side registration on the
rear side of the original in the ADF mode.
6-006*
4
ADF Registration
(Side-to-Side/Rear)
Use the
!
key to toggle between + and -
before entering the value. See
“Replacement and Adjustment - Copy
Adjustment” section 6.8 for details.
–7.0 ~ +9.5
0.5 mm/step
0.0 mm
Adjusts the magnification in the sub-scan
direction for ADF mode.
6-007*
ADF Sub-scan
Magnification
Use the
!
key to toggle between + and -
before entering the value. See
“Replacement and Adjustment - Copy
Adjustment” section 6.8 for details.
–0.9 ~ +0.9
0.1%/step
0.0%
Performs an ADF free run in duplex
scanning mode.
6-009
ADF Free Run
After selecting “1”, press “OK” or the
(
key
twice then set the paper to start this feature.
Press the
&
(Clear/Stop) key to stop.
0: No
1: Yes
6-010*
Stamp Position
Adjustment
Adjusts the stamp position in the sub-scan
direction in fax mode.
–10 ~ +10
1 mm/step
0 mm
Displays the status of the original size
sensors in the ADF.
6-901
ADF APS Data
Display
See the “DF APS Original Sensor Output
Display” section 4.2.13.
Selects the original scanning method in ADF
mode.
6-902*
ADF Scanning
Method
Do not change the setting.
0: Doc
(original)
1: Mag
(copy paper
size +
magnificatio
n)
6-905*
ARDF Skew
Correction
Selects whether the skew correction is done
or not when the ARDF feeds the rear side of
the original.
0: No
1: Yes
Adjusts the amount of original buckle at the
ARDF registration roller when the ARDF
feeds the rear side of the original.
6-906*
ARDF Original Curl
Adjustment
This SP mode is only effective when SP 6-
905 is at “1”.
-20 ~ +20
1 mm/step
0 mm
6-910
ADF/Printer Free
Run
This SP is for the designers only do not
perform this SP mode.
0: No
1: Yes