Ricoh Aficio 270 - Page 236

SERVICE PROGRAM MODE
A265/A267 4-50 SM
Mode No.
Class
1 and 2
Class
3
Function Settings
5-944*
APS Mode Setting
Selects whether APS mode is selected as
the power-up default.
0: Disabled
1: Enabled
Selects whether auto off is disabled when
there are sheets in the exit tray.
5-946*
Auto Off Disabling
If the LED does not light when paper enters
the tray, the user cannot easily see if paper
is there or not.
1: For machines with no fax/printer option,
the machine does not do auto off (with
the fax/printer option, the machine will
go to night mode but the LED still
works).
0:
For machines with a fax/printer option,
the machine does not light the exit tray
LED even in night mode.
0: No
1: Yes
5-950*
By-pass LG Size
Detection
For American models only
Selects whether the machine can detect LG
paper or LT paper in the by-pass tray.
0: No
1: Yes
5-951*
Inter Leaves Count
Setting
Selects the interleave count when interleave
mode is selected with User Tools (System
Settings - Print Priority).
In interleave mode, the machine will print 5
pages of one job, then 5 pages of the other
job, and so on.
1 ~ 20
1
pages/step
5 pages
Selects the paper type for the by-pass tray
at power-up or after pressing the
"
key.
5-952*
Paper Type Reset
(By-pass Tray)
If this is “2”, the previously used paper type
will be selected.
0: Thick
1: Plain
2: Hold
This is for the designer’s test purposes.
5-991
VRAM Data
Download
Do not change the value.
0: No
1: Yes
Prints the machine status history data list.
See the “SMC data Lists” section 4.2.7 for
how to print the lists.
5-992
SMC Printing
“5” is for facsimile transmission.
1: SP
2: UP
3: Log
4: All
5: Big Font
Adjusts the side-to-side registration in the
ADF mode.
1
ADF Registration
(Side-to-Side)
Use the
!
key to toggle between + and -
before entering the value. See
“Replacement and Adjustment - Copy
Adjustment” section 6.8 for details.
–7.0 ~ +9.5
0.1 mm/step
0.0 mm
Adjusts the leading edge registration in the
ADF mode.
6-006*
2
ADF Registration
(Leading Edge)
Use the
!
key to toggle between + and -
before entering the value. See
“Replacement and Adjustment - Copy
Adjustment” section 6.8 for details.
–5.0 ~ +5.0
0.1 mm/step
0.0 mm