PRINTING FEATURES
A265/A267 2-10 SM
Sub-scan Reduction Enabled
When Sub-scan Reduction is enabled, the received fax image is reduced in the
page memory to fit on the selected paper, if the received image length is between
[paper length - 4 mm] and [paper length + 20 mm]. See the drawing below.
NOTE:
The upper limit (page length +20 mm) is adjustable between 0 and 155
mm. Refer to Printer Switch 04, bits 0 to 4 for more details.
If the FCU detects that the image must be separated into more than one page after
reduction, what happens to the data depends on the Reduction Rate Equalization
setting (Printer Switch 0E, bit 7).
- Reduction Rate Equalization Off (Example Diagram: Two-page Printout) -
1. The data up to [page length –4 mm] will be printed on page 1, without
reduction.
2. The last 10 mm of this data will be repeated at the top of the next page (this
length can be can be adjusted or repetition can be switched off).
3. The remaining data will be printed on page 2, with reduction, if it is within
[paper length + 20 mm].
4. If it is longer than this, page separation is done again. Data up to [page length -
4 mm] will be printed on page 2, without reduction.
5. The process for page 3 and subsequent pages will repeat from step 2.
A895D525.WMF
A895D524.WMF
To Next Page
Loading...
