PRINTING FEATURES
SM 2-11 A265/A256
Detailed
Descriptions
A895
- Reduction Rate Equalization On (Example Diagram: Two-page Printout) -
1. The machine determines how many pages will be needed to print the message,
taking the following into account:
The final page (n) is such that the received image length is within (paper length x n)
+ 20 mm
The data must be reduced to fit on pages of length (paper length - 4 mm), with an
equal reduction rate for each page.
The last 10 mm of the previous page will be repeated at the top of the next page
(this length can be adjusted or repetition can be disabled).
2. The machine prints all the pages, at the same reduction rate.
If the customer does not want to receive a fax message on separate pages, page
separation can be disabled. However, once it has been disabled, the machine does
not print the received fax message until a paper size which can hold the received
fax image on one page is set in a cassette. Keep page separation enabled if the
customer expects to receive fax messages longer than the installed paper.
Cross Reference
Parameter Switch Default Setting
Reduction in sub-scan direction
on/off
Printer Switch 03, bit 0 Enabled
(except Germany)
Equalizing reduction rate among
separated pages
Printer Switch 0E, bit 7 Enabled
Page separation threshold when
reduction is disabled
Printer Switch 03, bits 4-7 6 mm
Page separation threshold when
reduction is enabled
Printer Switch 04, bits 0-4 20 mm
Page separation on/off Printer Switch 0E, bit 2 Enabled
Page separation mark on/off Printer Switch 00, bit 0 Enabled
Image duplication with page
separation, on/off
Printer Switch 00, bit 1 Enabled
Length of the repeated image on
the next page
Printer Switch 04, bits 5-6 10 mm
A895D528.WMF
To Next Page
Loading...
