BIT SWITCHES
SM 4-19 A265/A267
Service
Tables
A895
I/O rate 0: 0 ms/line 10: 10 ms/line
25: 2.5 ms/line 20: 20 ms/line
5: 5 ms/line 40: 40 ms/line
Note:
ā40ā is displayed while receiving a fax message using AI short
protocol.
G4 Communication Parameters
Compression
mode
MMR: MMR compression
MR: MR compression
MH: MH compression
Resolution
21: Standard (200 x 100 dpi)
22: Detail (200 x 200 dpi)
44: Superfine (400 x 400 dpi)
Width and
reduction
A4: A4 (8.3"), no reduction
B4: B4 (10.1"), no reduction
A3: A3 (11.7"), no reduction
Transfer T: Transfer
- : Other
Confidential
C: Confidential
- : Other
Other parameters
The following information is shown in 6-bit format. Bit 1 is the first
bit from the left, and bit 6 is at the right end.
Bit 1 - Smoothing 0: Off, 1: On
(Smoothing is disabled in halftone mode.)
Bit 2 - CIL printing 0: On, 1: Off
Bit 3 - Not used
Bit 4 - mm/inch conversion 0: Off, 1: On
Bit 5 - Engine type 0: mm, 1: inches
Bit 6 - Document resolution unit 0: mm, 1: inches
System Switch 01
No FUNCTION COMMENTS
0
Automatic Service Call at PM
0: Disabled
1: Enabled
This bit switch determines whether the machine
will send an Auto Service Call to the service
station when it is time for PM.
Cross reference
Auto service calls: Section 2.1
1-7
Not used Do not change the settings.
Rev. 02/2000
To Next Page
Loading...
