Ricoh Aficio 270 - Page 639

BIT SWITCHES
A265/A267 4-40 SM
Printer Switch 0E
No FUNCTION COMMENTS
2 Page separation
0: Enabled
1: Disabled
1: If all paper sizes in the machine require page
separation to print a received fax message, the
machine does not print the message (Substitute
Reception is used).
After a larger size of paper is set in a cassette, the
machine automatically prints the fax message.
3
to
4
Printing the sample image
on reports
Bit 4 Bit 3 Setting
0 0 The upper half
only
0 1 50% reduction
in sub-scan only
1 0 Same size
1 1 Not used
“Same size” means the sample image is printed at
100%, even if page separation occurs.
User Parameter Switch 19 (13H) bit 4 must be set
to “0” to enable this switch.
Refer to Detailed Section Descriptions for more on
this feature.
5-6
Not used Do not change the settings.
7
Equalizing the reduction ratio
among separated pages
(Page Separation)
0: Enabled
1: Disabled
0: When page separation has taken place, all the
pages are reduced with the same reduction ratio.
1: Only the last page is reduced to fit the selected
paper size when page separation has taken place.
Other pages are printed without reduction.
Printer Switch 0F
No FUNCTION COMMENTS
0
to
1
Smoothing feature
Bit 1 Bit 0 Setting
0 0 Disabled
0 1 Disabled
1 0 Enabled
1 1 Not used
(0, 0) (0, 1): Disable smoothing if the machine
receives halftone images from other
manufacturers fax machines frequently.
2 Duplex printing
0: Disabled
1: Enabled
1: The machine always prints received fax
messages in duplex printing mode:
3 Binding direction for Duplex
printing
0: Left binding
1: Top binding
4 Printing fax messages in user
code mode
0: Enabled
1: Disabled
1: The machine holds the received fax messages
until the machine exits the restricted access mode
(user code or key counter).
If the machine enters the restricted access mode
again while printing fax messages, the machine
stops printing the machine exits the mode again.
5
Not used Do not change the setting.