11
When moving the machine, hold the inset grips at both sides, and then lift •
the printer slowly. Lifting it carelessly or dropping it may cause an injury.
Important
Rating voltage of the connector for options: Max. DC 24 V.
Voltage must not fl uctuate more than 10%.
Handling the machine’s interior
This section explains safety precautions about handling the machine’s interior.
WARNING: R
Do not remove any covers or screws other than those explicitly men-•
tioned in this manual. Inside this machine are high voltage compo-
nents that are an electric shock hazard and laser components that
could cause blindness. Contact your sales or service representative
if any of the machine’s internal components require maintenance,
adjustment, or repair.
Do not attempt to disassemble or modify this machine. Doing so risks •
burns and electric shock. Note again that exposure to the laser com-
ponents inside this machine risks blindness.
CAUTION: R
Some of this machine’s internal components get very hot. For this reason, •
take care when removing misfed paper. Not doing so could result in burns.
The inside of the machine could be very hot. Do not touch the parts with a •
label indicating the “hot surface”. Otherwise, an injury might occur.
When loading paper, take care not to trap or injure your fingers.•
During operation, rollers for transporting the paper and originals revolve. •
A safety device has been installed so that the machine can be operated
safely. But take care not to touch the machine during operation. Otherwise,
an injury might occur.
If the machine’s interior is not cleaned regularly, dust will accumulate. Fire •
and breakdown can result from heavy accumulation of dust inside this
machine. Contact your sales or service representative for details about and
charges for cleaning the machine’s interior.
Do not pull out the paper tray forcefully. If you do, the tray might fall and •
cause an injury.
To Next Page
Loading...
Need help?
General