4. When Using the Printer under Mac OS
X
This chapter explains how to install and configure the printer drivers for use on the Mac OS X operating
system.
Installing the Printer
This section explains how to configure a Mac OS X to use EtherTalk, USB, and TCP/IP.
Follow the procedure below to configure Mac OS X 10.3.8. If you are not using Mac OS X 10.3.8, see
the manual of the Mac OS X you are using for details.
• Mac OS X 10.2 or higher is required.
• The PPD files are stored in the following folder on the CD-ROM: MacOSX PPD Installer
• If
you want to use AppleTalk, use the control panel or Web Image Monitor to enable it. (The default
is Inactive.) AppleTalk cannot be used under Mac OS X 10.6.
Installing the PPD Files
Follow the procedure below to install a PPD file to print from Mac OS X.
• You need an administrator name and a password (phrase). For details, consult your administrator.
1. Insert the CD-ROM into the CD-ROM drive.
2. Double-click the CD-ROM drive icon.
3. Double-click the [Mac OS X] folder.
4. Double-click the [(brand name)] folder.
5. Double-click
the [Mac OS X 10.2 or later] or [Mac OS X 10.5 or later] folder, depending on
your operating system.
6. Double-click the [MacOSX PPD Installer] folder.
7. Double-click the package file icon.
8. Follow the instructions on the screen.
43
To Next Page
Loading...
Need help?
General