Viewing settings
msh> wins
• If the IPv4 address obtained from DHCP differs from the WINS IPv4 address, the DHCP address
is the valid address.
Configuration
msh> wins "interface_name" {on | off}
• {on} means "active" and {off} means "inactive".
• Be sure to specify the interface.
• wlan can be specified only when the Wireless LAN interface unit is installed.
Interface name Interface configured
ether Ethernet interface
wlan Wireless LAN interface
Address configuration
Use the following command to configure the WINS server IP address:
msh> wins "interface_name" {primary|secondary} "IP address"
• Use the "primary" command to configure the primary WINS server IPv4 address.
• Use the "secondary" command to configure the secondary WINS server IPv4 address.
• Do not use "255.255.255.255" as the IPv4 address.
NBT (NetBIOS over TCP/IP) scope ID selection
You can specify the NBT scope ID.
msh> wins "interface_name" scope "ScopeID"
• The scope ID can be entered using up to 31 alphanumeric characters.
• Be sure to specify the interface.
• wlan can be specified only when the Wireless LAN interface unit is installed.
Interface name Interface configured
ether Ethernet interface
wlan Wireless LAN interface
wsmfp
Use the "wsmfp" command to view and configure the WSD (Device) and WSD (Printer) settings.
Using telnet
77
To Next Page
Loading...
