Maintenance Menu
You
can set printing conditions such as density and calibration, and printer management such as deleting
temporary print jobs from the hard disk.
Maintenance Menu Parameters
This section explains about parameters that can be set on the maintenance menu.
Quality Maintenance
Image Density Adjustment
Adjusting
the print image density can prevent faint spots or smears appearing on printed pages. You
can specify a density value between
3 and 3.
Only
change this setting from its default value if necessary. For details about adjusting the print image
density, see "Adjusting the Image Density", Hardware Guide.
Registration
You can adjust the starting position of the printing page. For details, see "Adjusting Printing Position",
Hardware Guide.
• Print Test Sheet
You can print the registration test sheet.
Only the installed trays appear on the display panel.
• Tray 1
• Tray 2
• Tray 3
• Tray 4
• Tray 5
• Bypass Tray
• Duplex Unit
• Adjustment
You can select the start position for printing on a page.
Only the installed trays appear on the display panel.
• Horizontal: Tray 1
• Horizontal: Tray 2
• Horizontal: Tray 3
4. Making Printer Settings Using the Control Panel
96
To Next Page
Loading...
