• Set comment using up to 31 characters.
Notify print job completion
msh> smb notif {on | off}
• To notify print job completion, specify "on". Otherwise, specify "off".
Deleting Computer Name
msh> smb clear comp
Deleting Group Name
msh> smb clear group
Deleting Comment
msh> smb clear comment
View Protocol
msh> smb protocol
snmp
Use the "snmp"
command to display and edit the SNMP configuration settings such as the community name.
View settings
msh> snmp
• Default access settings 1 is as follows:
Community name:public
IPv4 address:0.0.0.0
IPv6 address:::
IPX address:00000000:000000000000
Access type:read-only
Effective Protocol:IPv4/IPv6/IPX
• Default access settings 2 is as follows:
Community name:admin
IPv4 address:0.0.0.0
IPv6 address:::
IPX address:00000000:000000000000
Access type:read-write
Effective Protocol:IPv4/IPv6/IPX
• If "-p" is added, you can view settings one by one.
• To display the current community, specify its registration number.
Using telnet
65
To Next Page
Loading...
