1. Command Configuration
This chapter explains how to set up a network printer and check print status.
Before Setup
This section explains the preparation procedures required before you can use commands.
• To print from a UNIX workstation, use a file that the printer supports.
• Setting up varies depending on the printing commands. Make sure to make settings accordingly.
Using the lp/lpr Commands
1. Use the installation shell script to register the device option, as well as the printer host name
and the IP address.
For details, see p.7 "Using the Installation Shell Script".
2. Start printing.
For details, see p.16 "Printing Method".
Using the rsh/rcp/ftp Commands
• Only the standard UNIX rsh and rcp commands are supported.
1. Edit the host file to register the printer host name and the IP address.
For details, see p.11 "After Executing the Installation Shell Script"
2. Start printing.
For details, see p.16 "Printing Method".
• If you cannot edit the host file, use the install shell script to register the host name.
Windows Setup
Follow the procedure below to make network environment settings.
5
To Next Page
Loading...
Need help?
General